Is there a way to control the relays on the i/o board when using the external control programs? The only settings i see are speed/flow percentage settings... would be nice if it is possible... right now there is a 4 way air switch that turns the pump pump on and off by cutting the power, because i am using the relays to turn on the heat pump and the 1/2 hp pump where the heat pump is connected to. If i use the digital input than the only option is to cut the power of the heat pump completely, but i am not sure if that is a good thing to do ( i guess not)
Intelliflo3 digital input relay control
- Thread starter jeroen.tesselhoff
- Start date
-
- Tags
- i/o board intelliflo3 relays
- Jul 21, 2013
- 65,118
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60