Intellicenter firmware 2.017 - Filter pump will not turn on

[JohnS530]

My OCP just asked me to update to Firmware 2.017.
Now my filter pump will not turn on.

Pump: Pentair Intelliflo VF pump 011012.
The display on the pump says: Display Not Active, which is normal.
If I put the panel into Service mode, I can operate the pump normally, using the pump panel.

If I roll back the firmware to 1.067, the pump works fine.

I do hear a quiet "click" on the pump panel about every 30 seconds. Any ideas?

 

[ajw22]

When you go back to 2.017 check that a pump speed is set for the POOL circuit under the PUMPs configuration.

 

[JohnS530]

Yes, I checked the pump speed for the Pool circuit, and the Pump config. All looks good. Pump speeds are set. When I check Pump Status, it says "Priming".