I'm having some problems with my indoor controller which is running 2.017. Not sure how it got 2.017 because I didn't upgrade it and my intellicenter is running 1.064. I tried rolling it back to 1.064, but it keeps saying update failed... Any ideas on how to roll it back?
Indoor controller running 2.017
- Thread starter 21hamptonbays
- Start date
- Jul 21, 2013
- 65,362
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
How long have you had the OCP and ICP working?
Have you tried putting 1.064 on a USB key and putting the key in the ICP and doing a firmware update from it?
If all fails then call Pentair Support and speak to an IntelliCenter specialist.
Have you tried putting 1.064 on a USB key and putting the key in the ICP and doing a firmware update from it?
If all fails then call Pentair Support and speak to an IntelliCenter specialist.
Long story..... was working fine and then had an electrical surge and it blew out my outdoor board, which I had to replace.
I tried putting it 1.064 on a usb key, but it won't roll back...
- Jul 21, 2013
- 65,362
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
OK, so you were on 2.017 for the OCP and ICP, blew out the OCP, and replacement came with 1.064.
Upgrade your outdoor board to 2.017.
I am running 2.017 on my OCP and ICP and it works fine.
Call Pentair Support to sort out which way to go and get the correct firmware load.
Upgrade your outdoor board to 2.017.
I am running 2.017 on my OCP and ICP and it works fine.
Call Pentair Support to sort out which way to go and get the correct firmware load.
- Jul 21, 2013
- 65,362
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
If you have your blown IntelliCenter board consider sending it to @ogdento
He is collecting blown out boards that many of us are having and trying to determine where and why they are blowing and any repair procedures.
He is collecting blown out boards that many of us are having and trying to determine where and why they are blowing and any repair procedures.