Pentair Ichlor30 connected to Pentair Intelliflo3 vsf relay IO board. I have no clue what to purchase (wires) to connect the 2 together. I just installed salt cell and it needs to be connected to the pumps timer. Not a lot of info out there for that. I just purchased the up board. But have no clue how to connect the 2.
Ichlor 30 connect to up board intelliflo3 vsf pump
- Thread starter megslgregory
- Start date
- Jul 21, 2013
- 53,026
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
If you can use the Smart Sense Flow Detection feature of the iChlor....
Connect the GRN & YEL screws in the Power Center to the Intelliflo3 pump RS-485 connector.
If you can use the Smart Sense Flow Detection feature of the iChlor....
Connect the GRN & YEL screws in the Power Center to the Intelliflo3 pump RS-485 connector.
- Jul 21, 2013
- 53,026
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
- Jul 21, 2013
- 53,026
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Southwire (By-the-Foot) 22/4 Gray Stranded CU CL3R Shielded Security Cable 57572499
The South wire Gray 22/4 CL3R Security Wire is suitable for interconnection of electrical devices within a security or fire-protective signaling system. This wire is suitable for use in either dry or damp locations. It is made with stranded copper conductors.
www.homedepot.com
Use a length of cat5 cable if you have it. 18-24 awg solid or stranded wire, shielded or twisted doesn’t matter. It is a low speed protocol and not sensitive to cabling.
If you use cat5 cable twist a pair of wires together and use it as one wire. Cat5 has 8 wires in 4 twisted pairs.
You only need 2 wires to connect Yellow and Green.