Ic40 Salt Output blinking lights ...

[Dk1Projekt]

These lights will not turn off.

1) cell has been acid washed
2) I’ve even tried to calibrate it but it’s not letting me steps. (Maybe I’m doing it wrong?) got it off PentAir site
3) I’ve pressed them to turn off boost mode as well. And it goes back to blinking lights.
4) the SWG is only 12 months old so it can let be “dead”
5) I don’t see any build up in the SWG as well. Blades r good
6) salt levels are adequate was 3500.
7) what am I missing ??


thank u

 

[JamesW]

Are all of the lights blinking or just the Salt Level Good light?

 

[Jimrahbe]

D,

I'm pretty sure you cannot calibrate any of the new cells.. The calibration was for the older units..

If you are talking about the row of output percentages, they will blink anytime you are below 10%...

What output % are you trying set? Are you adjusting on an automation system or right at the cell?

Thanks for posting,

Jim R.