With my iAuquaLink solar enabled, the solar valve on and actually heating the Solar Heater virtual button won't show the word "heating" under it as it normally should. It seems to me that it used to as I do recall. In other words, the solar works as it should with iAuqalink but just won't show the word "heating" when it is actually heating. I have a One Touch wired remote panel as well. When solar heat is enabled It shows a red led when heating and a green light when not. This is working correctly so I would assume it's getting the right signal. Could it be a glitch in the iAuqaLink software?
I would appreciate any ideas. Thanks.
I would appreciate any ideas. Thanks.
Last edited: