- Jun 11, 2016
- 56
- Pool Size
- 12000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
Ok...I've been told because I have an SWG that the biggest challenge will be to keep my TA and PH low. I've been constantly running at 140 TA for last two months. Today the read on TA was 165. WTH?
Here are my numbers:
FC- 8 [normally around 5 but I reduced pump run time in half (3 hrs instead of 6) and didn't change aquapure percentage]
PH - 8.2+
TA - 165
CYA - 70
Salt - 2800
CH - 375
Temp - 69
I'm adding on average about 56oz of Muriatic Acid every week.
Today I added 30lbs of Salt per Pool Math recommendation and also Lowered my aqua pure to 15% from 25%.
Is there something else I should be doing.
Thanks,
Mike
Here are my numbers:
FC- 8 [normally around 5 but I reduced pump run time in half (3 hrs instead of 6) and didn't change aquapure percentage]
PH - 8.2+
TA - 165
CYA - 70
Salt - 2800
CH - 375
Temp - 69
I'm adding on average about 56oz of Muriatic Acid every week.
Today I added 30lbs of Salt per Pool Math recommendation and also Lowered my aqua pure to 15% from 25%.
Is there something else I should be doing.
Thanks,
Mike