I have an aquarite goldline control panel. When the pool is first turned on the control panel display is the usual flashing "no flow" light. That light goes away in the usual amount of time, and the "generating" and "check cell" lights come on. After about 5 seconds all the lights shut off. I know it is not reading the correct amount of salt either. The wire to the flow switch did get broken, but it was repaired. Also, we currently have a brand new t-9 cell. Any ideas on if this is a flow switch, control panel, or salt cell problem. Hoping I can narrow it down to one.
Help trying to isolate problem...
- Thread starter Amyandmike02
- Start date
Hayward Aquarite SWG - Further Reading
www.troublefreepool.com
Similar threads
