During the installation of the plumbing the PB plumber broke one of the flanges on a Hayward return fitting, it will obviously have to be replaced. Is there a process for doing this to ensure good adhesion to the pool again?
Luckily there is no water in the pool as we are in the early stages of the install.
The first return was installed with BOSS 801 silicone and I just want to make sure that the new return is sealed properly.
Luckily there is no water in the pool as we are in the early stages of the install.
The first return was installed with BOSS 801 silicone and I just want to make sure that the new return is sealed properly.