Last week I went by the Heater and it had some error code on it like Sb or 56? Hit the buttons to operate and the heater did not respond. I have not used the heater in about 6 weeks.
The electronic display interface has a thin plastic laminte that came off from the heat of the AZ sun. I taped it back on and it came off again. We have had some consistent rain, so I was thinking some water might have messed up the control module. I was planning to replace it soon any ways.
So do you think it was the module part, or something else? I will share pics later.
The electronic display interface has a thin plastic laminte that came off from the heat of the AZ sun. I taped it back on and it came off again. We have had some consistent rain, so I was thinking some water might have messed up the control module. I was planning to replace it soon any ways.
So do you think it was the module part, or something else? I will share pics later.
