My pump randomly stops running. Typically in the past if this has happened I get a low flow alarm. I am not seeing any alarms on the pump or on my omnilogic panel. If I go to the the pump diagnostics there are no errors. When this occurs I can just start the pump up again by going to the omnilogic panel and turning the pump back on It starts and runs no problem until the next time it randomly turns off. Does anyone have any tips on how to further isolate what the problem might be?
Hayward SP32950VSP Pump randomly stops running without any alarm or error
- Thread starter m1k_3
- Start date
- Jul 21, 2013
- 53,526
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
That looks like a TriStar VS pump.
Where is the power to the pump wired to? LINE or LOAD side of the filter/pump relay?
You carefully check the Omni programming?
Put some inexpensive cameras recording the pump, equipment pad, and OmniLogic panel to catch when the pump shuts off.
Post pics of the insides of your OmniLogic cabinet showing all the wiring.
Where is the power to the pump wired to? LINE or LOAD side of the filter/pump relay?
You carefully check the Omni programming?
Put some inexpensive cameras recording the pump, equipment pad, and OmniLogic panel to catch when the pump shuts off.
Post pics of the insides of your OmniLogic cabinet showing all the wiring.