Hayward HeatPro and Omnihub

[sierez]

Hi,
I'm trying to connect a Hayward HeatPro model HP21404T to our Omnihub. Everything I tried failed. I just went through the menu and find an Aff option and set that to P_S. Then config the Omnihub to add the Heater but can't control the heater through it.
Any advice will be really appreciate it.
Ramon

 

[ajw22]

First show us pics of how the HeatPro is wired to the Omnihub.

 

[sierez]

Sorry I'm not at the location right now. But, it is connected from PS pins on the the HPEC-003 heater's board to LV1 on the OmniHub.

What is different in this board is that P-S pins are labeled bo-HE instead.

Regards,
Ramon

 

[ajw22]

Using your multimeter test if LV1 is closing when you call for heat on the Omnihub.

 

[sierez]

Using your multimeter test if LV1 is closing when you call for heat on the Omnihub.

Thanks I'll check and let you know. But I think my problem is in the Heaterf config. I followed manual intructions but I'm not able to set P_S to E(External). Heater Main Menu only shows POL,SPA,and F_C. There is another menu when you keep pressing set key and press + key till 50 is displayed on screen. Then you can access a submenu under Aff, which provides you POL, SPA, and P_S. There is where I'm stuck right now.

Ramon