The plug is set for 120V. At first it was 240V, but it was switched the day of install. Thanks
Hayward HDF400 Universal Heater Issue
- Thread starter SoCalSteve72
- Start date
Next steps, measure pressure differential with gas output using a manometer.
Checking line voltage when heater is running to make sure I don’t have a voltage drop.
Checking all ground connections.
Checking Igniter.
If those don’t fix, then burner comes off for a clean, then ?
Checking line voltage when heater is running to make sure I don’t have a voltage drop.
Checking all ground connections.
Checking Igniter.
If those don’t fix, then burner comes off for a clean, then ?
Does anyone think because my DE filter clean runs normally at 25PSI would cause any of these issues.
My pump is 2hp and supposedly puts out about 73GPM, and heater can heat up to 125GPM.
My pump is 2hp and supposedly puts out about 73GPM, and heater can heat up to 125GPM.
- Jul 21, 2013
- 65,062
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
