Glad I found this site. Hoping for help. Aquarite in auto clicks after 10 sec, power and generating come on, then go off after a few seconds. Noticed volts drop to almost 0 then climb to about 18.3 ish. Clicks on again and goes out. Amps seem to be 0. Salt is approx 2100 on test, reading 1900 on AR.
Diag 5 times to salt reading and can only get -0. T15 cell new last year and clean and set to t15. Temp is 76. Put a little dielectric grease on cell connectors and went in and out gently. No difference. Any clues here? Is Salt to low? I want to add but as
lso want to be sure I’m reading accurately. Does not show low salt warning, however, cycling off to auto flashes red once quickly.
Shouldn’t it at least come on? Or am I just an idiot! Thanks…
Diag 5 times to salt reading and can only get -0. T15 cell new last year and clean and set to t15. Temp is 76. Put a little dielectric grease on cell connectors and went in and out gently. No difference. Any clues here? Is Salt to low? I want to add but as
lso want to be sure I’m reading accurately. Does not show low salt warning, however, cycling off to auto flashes red once quickly.
Shouldn’t it at least come on? Or am I just an idiot! Thanks…
