Hi all. I'm looking for in-the-field experience as to whether the "low" flow on a 2-speed Hayward Superpump is too low for SWG production or heater operation.
My Hayward Superpump 1 HP single speed needs a new seal, and if I hire the labor out...am thinking I might as well upgrade to 2 speed...I will go dig up the specs and try to predict, but if you've run this pump and have any observations, please share.
The hayward specs don't seem to show rpm on low.
Oops, Hayward's site des say 1725 rpm
I think my question now is whether on low speed it would produce adequate flow for the heater...
My Hayward Superpump 1 HP single speed needs a new seal, and if I hire the labor out...am thinking I might as well upgrade to 2 speed...I will go dig up the specs and try to predict, but if you've run this pump and have any observations, please share.
The hayward specs don't seem to show rpm on low.
Oops, Hayward's site des say 1725 rpm
I think my question now is whether on low speed it would produce adequate flow for the heater...