I have a Sundance Altamar just over five years old. On occasion I get a FLO error. When this happens the heater kicks off. So far, by adjusting the temperature lower than where it is when I notice it, I can wait and a few minutes and then raising it back up it seems to work again. As an example I went out there a little bit ago and the FLO error was showing and temp was 98°. It was set at when 104°, so I lowered the temp to 95°, waited a few seconds and put it back to 104° and it started heating again. This has happened probably 4-5 times over the last month. I replaced the filter about six weeks ago so it is clean. Any ideas? I have read where it could possibly be the "flow switch", how hard is it to change out?
Thx
Sent from my iPhone using Tapatalk
Thx
Sent from my iPhone using Tapatalk