Hello all! I have been stalking the site for a few days and figured I need to jump in.
Wife and I moved into a house with an in-ground pool that is approx 25K - 30K gallons. I have not been able to do an average depth measurement on the pool. I bought a K-2006 test kit before reading the site recommendations for 2006C. So far I have only increased the TA with pool store recommendation and last night I poured in 4 gallons of Liquid Chlorine 10% because the water was turning into a swamp.
Here are some tests from this morning.
CYA - 0 (pretty sure because the solution was not a bit cloudy)
PH - 8.0 (its been raining throughout the last week)
TA - 140
CH - 120
FC - ? (did not perform since there is still algae in the pool this morning but not as bad as last night)
I have been reading about SLAM and OCLT. What do you all recommend? I was thinking I should raise the CYA levels, check my pH levels after CYA before I start SLAM.
Thank you!
Wife and I moved into a house with an in-ground pool that is approx 25K - 30K gallons. I have not been able to do an average depth measurement on the pool. I bought a K-2006 test kit before reading the site recommendations for 2006C. So far I have only increased the TA with pool store recommendation and last night I poured in 4 gallons of Liquid Chlorine 10% because the water was turning into a swamp.
Here are some tests from this morning.
CYA - 0 (pretty sure because the solution was not a bit cloudy)
PH - 8.0 (its been raining throughout the last week)
TA - 140
CH - 120
FC - ? (did not perform since there is still algae in the pool this morning but not as bad as last night)
I have been reading about SLAM and OCLT. What do you all recommend? I was thinking I should raise the CYA levels, check my pH levels after CYA before I start SLAM.
Thank you!