Pretty experienced at this but getting around to dialing in post AZ winter here. PH is consistently testing high. I'm done adding anything as of right now, is it possible my reagents have expired? You can see my logs. I've added a bunch of MA and liquid chlorine. Both were just bought the other day. I also tested salt to 2800 and added probably about 1/8 of a 40 lb bag early this morning. Pump is running and just tested now at 2600? Going to test again later tonight to see if anything changed.
FC not raising and PH not dropping?
- Thread starter Uhhello
- Start date
- Jun 24, 2021
- 15,880
- Pool Size
- 29000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-60 Plus
Just add 20oz of your 14.5%, wait 1/2 hour and test again. Continue this cycle with 20oz until you read 7.8, then leave it there.
With a TA of 80, you may just be stable at 7.8 to 8.0 which is just fine.
2800/2600 is within the margin of error for the test.
With a TA of 80, you may just be stable at 7.8 to 8.0 which is just fine.
2800/2600 is within the margin of error for the test.
