Easytouch J20 Port Already Filled For Intelliflo

[johnssc1]

Trying to hook up the low voltage control line for an intelliflo to an easy touch. The J20 port on the board is already filled with a wire that goes back to the other control board. Do I double up the connections? Or do I need to use 'COM1' or 'COM2' on the rear board? They appear to be identical and go the the same chip on the board

 

[Jimrahbe]

John,

If they could fit, you could add 100 more items to J20..

Did your EasyTouch come with a built-in power center??? If so, I assume the "Rear Board" you are talking about is the Surge Card. It should have two empty com port connections.. There is just one com port (J20) and all the connection points are identical.. Assumes that your J20 has a small cable going to one of the three com ports on the surge card.

Thanks,

Jim R.

 

[johnssc1]

It must be the surge card. The cable connects to COM3. COM1 and COM 2 are open

 

[Jimrahbe]

John,

If the cable from J20 connects to com3, then com 1 and com2 are identical to J20...

Here is a pic of mine..



Thanks,

Jim R.