- Jun 24, 2021
- 9,075
- Pool Size
- 30000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-60
Dolphin DX3. Pool closed, just wanted to get leaves and oddly, lots of earthworms. It went around a bunch and boy did I get a sackfull. However, I noticed that it tended to go headlong into the wall and just sit there spinning.
Tracks are old, but the foam donuts, that I think are used for traction (tracks don't really touch the bottom?) are brand new. Liner is BRAND new. Water is about 47 degrees.
Thoughts?
Cold water? (just wait until it warms up).
Replace the tracks? (old hard rubber can't grip, especially with cold water, replace them).
New Liner? (Not sure if there is anything I can do about that).
Dead Dolphin (it generally worked, I got a bag full after I got it to "go around."
Do you agree that I should replace the tracks? or is this a behavior you see when a dolphin is dying? Or Dolphin is fine and I just need to wait for water temp to rise to use it?
What is your experience? THANKS!
Tracks are old, but the foam donuts, that I think are used for traction (tracks don't really touch the bottom?) are brand new. Liner is BRAND new. Water is about 47 degrees.
Thoughts?
Cold water? (just wait until it warms up).
Replace the tracks? (old hard rubber can't grip, especially with cold water, replace them).
New Liner? (Not sure if there is anything I can do about that).
Dead Dolphin (it generally worked, I got a bag full after I got it to "go around."
Do you agree that I should replace the tracks? or is this a behavior you see when a dolphin is dying? Or Dolphin is fine and I just need to wait for water temp to rise to use it?
What is your experience? THANKS!