Hello. We are in the process of prepping for the long awaited arrival of our Intex Ultra Frame XTR 24’ round pool (assuming it really does show up while it is still summer!). Does anyone have a diagram/placement measurements for the leg support pads?? We would like to get as much prep done before the pool arrives to make it a faster process once it gets here. Any help would be greatly appreciated!
Diagram for Intex Ultra XTR 24’ round?
- Thread starter NewPoolJim
- Start date
Hi, welcome to TFP! The best thing you can do for now is to create a level area to set up the pool. For a 24' pool you will want to level an area 26' to 28' around to make sure you have plenty of room to access the pool on all sides. Dig down to firm ground to level, do not try to build up low spots. You can rent a transit from a hardware store or build a water level to construct a level pad for the pool.
Thanks for replying! Yes, we did that. We were hoping to get the Footing supports in as well. That’s why we were hoping to find a diagram or information on how far apart each support was.
RoyalGorgeColorado
Bronze Supporter
RoyalGorgeColorado
Bronze Supporter
What we did was set just the top frame up and from there stuck the pavers underneath each leg and levelled everything like that. From there we then put the legs up doing every other leg till we got them all in. then we made sure each leg was straight and started filling. while filling, I hopped in with the pool brush and smoothed out the wrinkles. So far I have found this to be the easiest way.