Check Flow Error / Red Light Blinking

[qsch1]

Hello, The annoying red light is blinking. Usually this stops after cleaning the filters or putting in the adequate chemicals ie salt. I checked all the filters (3 of them) and they are all clean. The tri flow sensor has been replaced about two years ago and the cell about two years. I noticed that the computer is reading 0 volts (11.4 amps) on the cell? May be the cable to the cell?Any help would be much appreciated. Thank you

 

[ajw22]

Is this the Autopilot DIG 220 & PPC1 RC-35/22 Cell in your signature?

It is best to contact saltpoolguys for Autopilot problems…

SaltPoolGuys.com: AutoPilot Pool Pilot Experts

An authorized AutoPilot Pool Pilot & AquaCal dealer featuring replacement cells, parts, complete systems & heat pumps. Offers nationwide shipping.

www.saltpoolguys.com

 

[qsch1]

Is this the Autopilot DIG 220 & PPC1 RC-35/22 Cell in your signature?

It is best to contact saltpoolguys for Autopilot problems…

SaltPoolGuys.com: AutoPilot Pool Pilot Experts

An authorized AutoPilot Pool Pilot & AquaCal dealer featuring replacement cells, parts, complete systems & heat pumps. Offers nationwide shipping.

www.saltpoolguys.com

Yes correct that’s it!

 

[qsch1]

Thank you, it seems the Tri Sensor is bad. Can this be fixed or washed with an acid bath. A but surprised as only put it in about two years ago.

 

[ajw22]

Thank you, it seems the Tri Sensor is bad. Can this be fixed or washed with an acid bath. A but surprised as only put it in about two years ago.

Nope, gotta replace it.

 

[qsch1]

Nope, gotta replace it.

I swear this we put in only about two years ago, don't understand the lifespan on these things.