After replacing the PCB and adding iAquaLink, I cannot find the usual system setup settings in the iPhone app or on the website. This system does not have a wired controller. Am I going to have to buy one just to configure the rest of the system settings? I used to have AquaLink PDA system, but the PDA died which provoked me to upgrade.
Can’t find system setup options after upgrade to iAquaLink 3.0
- Thread starter jimrhyne
- Start date
- Jul 21, 2013
- 65,789
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
It is best (easier) to access the menu from a computer but doable from a phone app.
On the phone app you have click to go to web. Then that is the starndard view. Click on MENU at the bottom then go to System Setup.
