Ok so I have a small area I'm going to install a galvanized steel piece of sheet metal on the inside of my 27 foot AGP. I'm doing this because it's bowed out at the bottom of one upright where there's just too much room between tracks meeting in the footer. I'd resinstall the whole thing but I don't have the man power.
My question is can I drain the pool , and drop the liner in that one area(keep liner attached on 85% of pool), and then install my sheet metal on the inside as a reinforcement?
Would I then reattach the liner and maybe tape up a shop vac to one small area to get liner wrinkle free?
How do I make sure the liner gets resetup right? Any advice or tips? Thank you!
My question is can I drain the pool , and drop the liner in that one area(keep liner attached on 85% of pool), and then install my sheet metal on the inside as a reinforcement?
Would I then reattach the liner and maybe tape up a shop vac to one small area to get liner wrinkle free?
How do I make sure the liner gets resetup right? Any advice or tips? Thank you!