I’ve been trying to dial in the VSP speed for our Jandy TruClear SWG, and I’m getting this bubble forming in the top of the chlorinator. I assume this is chlorine and hydrogen gases that aren’t being dissolved or carried down line. The VSP is set at 1750 which is about 50%. There’s no air in the pump basket or filter. Also no flow warning from the cell. Should I be at all concerned or just ignore this?
Bubble Forming in Top of Jandy TruClear
- Thread starter s0cr4t1c
- Start date
- Jul 21, 2013
- 66,466
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Ignore it.
If they did not put a clear cover on you would never know about it or worry.
If they did not put a clear cover on you would never know about it or worry.
