Blank display

[red7089]

Hello everyone, I have been looking for help and maybe someone has some info that they can pass on.
I have a pentair superflo VS 342001 1.5 HP, it has the capability to hook up to 115-230, I have had it power with 115 for several years.
A couple of days ago it was not working as scheduled, I check it and the display panel was blank and all LEDS were blinking on half a second then of several seconds. I tested for power which was ok 120V. none of the buttons are responsive and I have cycled power several times with no luck. Any suggestions.

 

[ajw22]

Welcome to TFP.

When you cycled the power did you leave it powered off for a while so the electronics can hard reset? Maybe 30 minutes?

Sounds like your drive electronics has a problem. That is not repairable and usually buying a new pump is more economical than a new drive.

 

[red7089]

Thank you for the feed back, yes I powered off more than an hour turned back on with no change to the display is still off with leds blinking ever 20 seconds or so and power led bolt off.

 

[JamesW]

I tested for power which was ok 120V.

Did you measure hot to ground or hot to neutral?

What is the date on the front sticker?