I have an autopilot soft touch which isn't producing chlorine due to a low flow error. After cleaning all the filters, I continued to get the error even though I knew it was getting plenty of flow. I went ahead and replaced the tri-sensor and new cable and am still getting the error. Trying to figure out if there's anything else I can try or what I should replace next. Cheers.
Autopilot Soft Touch "Low Flow Warning" even after replacing tri-sensor
- Thread starter sballent
- Start date
- Jul 21, 2013
- 65,103
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
These guys are good at Autopilot support. Give them a call with your problem.
These guys are good at Autopilot support. Give them a call with your problem.
SaltPoolGuys.com: AutoPilot Pool Pilot Experts
An authorized AutoPilot Pool Pilot & AquaCal dealer featuring replacement cells, parts, complete systems & heat pumps. Offers nationwide shipping.
www.saltpoolguys.com