Hi all, was wondering if anyone has ever seen an aquatrol reading its salt as 1.60 instead of the typical 1200-1800ppm range? All summer my salt has been showing up normally at 1500-1600. Now its reading 1.60 and cant get it to read properly again. Its a T5 replacement cell installed in June of this year. I tried powering it down completely but it didnt help....thanks in advance!
Aquatrol registering salt in single digits
- Thread starter learning the pool world
- Start date
- Jul 21, 2013
- 65,393
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Your system is set to read in metric units.
The salt and temperature display can be in English units of ppm and F or changed to Metric units of g/l and C by the following:
The salt and temperature display can be in English units of ppm and F or changed to Metric units of g/l and C by the following:
- Slide the Main Switch to the "Auto" position.
- Push the Diagnostic button repeatedly until "ºF" appears on the display.
- Slide the Main Switch from "Auto" to "Super Chlorinate" and back to "Auto".
- Push the Diagnostic button to exit.
Thank you very much ajw, problem solved, really appreciate your help, thanks again!