When I first started up the system lights were fine, I would see the flow light flash until established and then went out. However, now that the system is about 1 week in use, I noticed that only the power light is on, and no other lights are functioning. Unplugging and replugging made no difference, I usually see the flow light flashing but that no longer happens either. I have set the switch to Auto at 100% generating, and no sign of any activity. Here are my diagnostics:
2300
67
32.1
0.00
100P
-0
AL -6
r1.45
Checked the 20A fuse on the board and it appears intact, no sign of it being shot.
I have not contacted Hayward Support but that was my next step after posting here. Hopefully someone can help me. The unit has only been used for one season.
Thank you.
2300
67
32.1
0.00
100P
-0
AL -6
r1.45
Checked the 20A fuse on the board and it appears intact, no sign of it being shot.
I have not contacted Hayward Support but that was my next step after posting here. Hopefully someone can help me. The unit has only been used for one season.
Thank you.