AquaRite 940 Omni kit

[DaBomb]

Hi,

Bought the AquaRite 940 Omni kit, and after 6 months of waiting, I finally received it.

Reading the manuals (which are all separate), I’m confused with two things.

1) There’s no specifics about where to connect the flow sensor, does it connect to the VS Onni or to the AquaRite 900 system?

2) The VS Omni only has one COMM BUS, however both the VS Omni pump connection and AquaRite connection state that they both connect to the COMMUNITY BUS, so how do I connect both to the same COMM BUS, and is there something I’m missing here?

Very much appreciate any assistance here.

Thanks in advance!

 

[ajw22]

Welcome to TFP.

1. Connect the flow switch to the Aquarite control panel.

2. You can usually fit two wires for one screw on the COMM bus depending on the gauge wire used. If not then connect a pig tail to the COMM bus and wire nut the two wires to the pig tail.

 

[DaBomb]

Thank you!