Aquapure SWG says No Flow and Cell Reversing
- Thread starter RuggedPool
- Start date
Eh, I'll just make the pb replace it. But surely that's not the root cause of my problems...
The circuit board is behind the main panel and it looks like this.
Since this is new, just file a warranty claim and replace the sensor module.
Since this is new, just file a warranty claim and replace the sensor module.
The system says "No Flow" so it is not going to turn on the SWG.
Replace the Trisensor and then you should get a good flow and the SWG should work.
Show the circuit board if you want us to look at that.
Do I need to unscrew all those screws behind the breakers? Or is there a simple set screw and it swings out? I assume I need to shut power to the panel?
I would replace the sensor.
Here is a test you can do.
Disconnect the sensor plug and use the three buttons to do the three tests.
Here is a test you can do.
Disconnect the sensor plug and use the three buttons to do the three tests.
Trying that now but struggling to disconnect the flow sensor. I don't want to break it. Does it just pull out?I would replace the sensor.
Here is a test you can do.
Disconnect the sensor plug and use the three buttons to do the three tests.
View attachment 529190
View attachment 529191
All 3 tests failedI would replace the sensor.
Here is a test you can do.
Disconnect the sensor plug and use the three buttons to do the three tests.
View attachment 529190
View attachment 529191
That is close enough.
I would call it a pass.
The salinity was probably recalibrated, which will change the number.
The other two are ok if +/- 1.
The sensor is obviously damaged due to water intrusion.
Contact Jandy and ask them to send you a new trisensor or get one from your builder under warranty.
Contact Jandy and ask them to send you a new trisensor or get one from your builder under warranty.
So just need a new module.
While I've got this thing opened up is there a reason I can't check any of these settings on my app?
The red plug is the communication plug.
The other end should connect to one of the red plugs in the second picture or in the third picture.
There should be a plug from the red plug in the second picture to one of the plugs in the third picture.
The third picture is the multiplex board and it allow extra communications connections, but the board needs to be connected to the main board.
The other end should connect to one of the red plugs in the second picture or in the third picture.
There should be a plug from the red plug in the second picture to one of the plugs in the third picture.
The third picture is the multiplex board and it allow extra communications connections, but the board needs to be connected to the main board.
got it...definitely wasn't hooked up. I'll just have the PB fix it when they replace the module. hopefully it won't take them forever.
Now in the meantime, I had put 6 bags of salt in 2 weeks ago and now I've got no chlorine. Do I just use chlorine tabs or liquid to maintain my levels until they fix the module?