The currently installed AquaPure generator has the sensor port closest to the flow output end. The new replacement AquaPure generator instructions show that the sensor port should be closest to the flow input end. Does it make any difference. I think the reason the current one is installed the way it is is because these isn't any room for the sensor to be on the flow in end unless the sensor is tipped to the side and not the bottom. Having it closest to the flow output end, will it cause any damage?
AquaPure SWG Installation
- Thread starter Ted307
- Start date
- Jul 21, 2013
- 53,130
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
The cell will work either way and the trisensor can be any orientation. At low flow, the preferred position for the trisensor is down. The new cell has a preferred direction as indicated by the arrow.
What is considered low flow, I currently have the InteliPump set at 2200 for the cleaner 5:00AM to 10:AM, then dropping down to 1500 10:00AM to 5:00PM and then off. Running at 2750 for Spa useage