Back in February, my SWG produced an error code of 170. After troubleshooting using a meter to measure current, it appeared to be a front board issue. I replaced the front board with what I thought was a good board and I am still getting a 170 error message. I am not sure about the new board since Jandy does not make my old board anymore.
At any rate, when I plugged in my old board, I was elated that the 170 error code did not appear. Then I realized I did not plug in the flow sensor, I turned the system off and plugged in the flow sensor and the 170 error code appeared once again. Could this mean that its still the front board issue?
At any rate, when I plugged in my old board, I was elated that the 170 error code did not appear. Then I realized I did not plug in the flow sensor, I turned the system off and plugged in the flow sensor and the 170 error code appeared once again. Could this mean that its still the front board issue?