This is my first ever post to a forum.
I have an RS6 pool/spa with a Filter, Polaris, Waterfall booster pump, blower, pool lights, and spa light relays being utilized. When either or both pool or spa light button is pushed the relays just click a few times then stop. Power is fed to the relays from a nearby GFCI which I have replaced as well as new relays. I wired the power in from the gfci straight to the wire one goes out to the lights and all lights function without tripping GFCI. I finally moved the red relay plug for a light to the blower/aux 3 relay plug. When I push blower on, lights work fine. Plugged blower red relay plug into either light connection on board and same clicking. I tested power while engaging the relays and it jumps to 80v then 40 then 0. Very weird issue, does it have something to do with the board perhaps?
I have an RS6 pool/spa with a Filter, Polaris, Waterfall booster pump, blower, pool lights, and spa light relays being utilized. When either or both pool or spa light button is pushed the relays just click a few times then stop. Power is fed to the relays from a nearby GFCI which I have replaced as well as new relays. I wired the power in from the gfci straight to the wire one goes out to the lights and all lights function without tripping GFCI. I finally moved the red relay plug for a light to the blower/aux 3 relay plug. When I push blower on, lights work fine. Plugged blower red relay plug into either light connection on board and same clicking. I tested power while engaging the relays and it jumps to 80v then 40 then 0. Very weird issue, does it have something to do with the board perhaps?