Hi
i want to reduce my electricity bill and take advantage of my vsp by running at night at low rpm just for filtration and not heating. My question is is this something the aquacal is set up for - will it automatically detect a low flow rate and stop heating and then automatically when the flow rate goes up start heating again - all without damaging the heat pump or going into some error mode?
thanks
i want to reduce my electricity bill and take advantage of my vsp by running at night at low rpm just for filtration and not heating. My question is is this something the aquacal is set up for - will it automatically detect a low flow rate and stop heating and then automatically when the flow rate goes up start heating again - all without damaging the heat pump or going into some error mode?
thanks