I've had an Aqua Rite Goldline T-15 for a little over 2 years now, and it has worked great to this point. However, for some reason I now can't seem to keep chlorine up in the pool. The only LEDs on are solid green for "Power" and "Generating" (just like I would expect for nominal ops). Now for the clues...
With the chlorine setting set to 100%, Current shows as 0A, and the Instantaneous Salt level 0 as well. At one point, I did flip the toggle from "Auto" to "Off", then "Super Chlorinate" then back to Auto. A few seconds later I heard a click and current then showed at 4.4A and Inst Salt at -2200. This seemed to last for about 45 minutes and then went back to 0, 0 again.
The numbers (from Diagnostics):
Average Salt: 3400
Temperature: 58 deg F
Voltage 33.3V (seems a little high?)
Current: 0 (at least most of the time)
Chlorine setting: 100p
Instantaneous Salt: 0
AL-0
Version: r 1.59
T-15
Other numbers:
FC: 3 (yikes) -- adding liquid
PH: 7.8
TA: 70
CH: 500+
CYA: 70
I'm in Southern California, and normally, for the colder months, I would have the dial set to 40% chlorine and easily maintain FC level above 6. Lastly, the cell is clean -- just cleaned a few weeks ago and wasn't that bad when I did it.
Thoughts?
With the chlorine setting set to 100%, Current shows as 0A, and the Instantaneous Salt level 0 as well. At one point, I did flip the toggle from "Auto" to "Off", then "Super Chlorinate" then back to Auto. A few seconds later I heard a click and current then showed at 4.4A and Inst Salt at -2200. This seemed to last for about 45 minutes and then went back to 0, 0 again.
The numbers (from Diagnostics):
Average Salt: 3400
Temperature: 58 deg F
Voltage 33.3V (seems a little high?)
Current: 0 (at least most of the time)
Chlorine setting: 100p
Instantaneous Salt: 0
AL-0
Version: r 1.59
T-15
Other numbers:
FC: 3 (yikes) -- adding liquid
PH: 7.8
TA: 70
CH: 500+
CYA: 70
I'm in Southern California, and normally, for the colder months, I would have the dial set to 40% chlorine and easily maintain FC level above 6. Lastly, the cell is clean -- just cleaned a few weeks ago and wasn't that bad when I did it.
Thoughts?