Hi...
I need help...
I have a P4 AquaL ogic and I am having a message of High Salt / Amps.
This started 2 weeks ago when the entire system failed. I thought first that my pump which was making a lot of noise (probably the beering) was broken. So, I have this Hayward 2 speed 1.5hp pump replaced by an Hayward Variable speed Sp26000 pump. The pump has been connected to the P4 by a technician and when got back from work I had this message.
As they told me that I may need to have the P4 main board replaced, I went on internet and found out this forum. So, since the section of the relay was burned, I put a little glob of solder on the back of the card and I changed the fusible (20 to 15 amp). Unfortunnately that didn't resolved the problem. I removed the card and went to an electronic store where the replaced the relay and ensure that all transistor and other circuits were good. Again it didn't change the issue.
My panel shows 2400 ppm but the pool store reads 3500 ppm on a water sample. They said that this should not be the problem because the aqualogic panel reads 2400 ppm.
My cell (C15) was replaced a month ago and she was working fine as I did a super chlorinate for 24 hours to bring my pool water to green to clear. This was I always do in the Spring.
So, any suggestion? Since my card has been verified and fix with the relay replaced, the cell is new and as well as the pump.
Thanks for any help.
André