Just got my pool setup the other day, had the water tested at a local pool store because I didn't pay attention to the shipping for my TF100 test kit. I figured it was better than nothing and their results seemed pretty spot on to what my TF100 kit gave me.
Anyway, here are my results:
FC: 0.5
CC: 0.5
PH: 7.9
TA: 130
CH: 120
CYA: 0
Salt: 2150 (I knew I needed to add more salt, I initially added 80lbs and didn't want to go over so I left it until I could actually get this number tested).
I have gone over the recommended levels with the SWG and plugged in my levels in the calculator, I can read what I need to add but basically I am confused on what order I need to add things.
I see some chems reduce one thing while increasing another so I don't want to throw something out of whack by going in a wrong order. If anyone can point me in the right direction I would greatly appreciate it!
Pool specs are in my signature.
Anyway, here are my results:
FC: 0.5
CC: 0.5
PH: 7.9
TA: 130
CH: 120
CYA: 0
Salt: 2150 (I knew I needed to add more salt, I initially added 80lbs and didn't want to go over so I left it until I could actually get this number tested).
I have gone over the recommended levels with the SWG and plugged in my levels in the calculator, I can read what I need to add but basically I am confused on what order I need to add things.
I see some chems reduce one thing while increasing another so I don't want to throw something out of whack by going in a wrong order. If anyone can point me in the right direction I would greatly appreciate it!
Pool specs are in my signature.