Some of the feet on my 18 ft 48 in AG pool have sunk in completely under the soil, so you can't see the plastic cap any longer. It's been up two weeks now. Our soil is sandy. It's got the pool just about 2 inches off of being level. Is this something to be concerned about?
AG Pool feet sinking
- Thread starter Tatum4701
- Start date
- Jul 21, 2013
- 53,029
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Yes, your pool is approaching the unlevel danger point. 3 inches the maximum a pool should be off. Did you put the feet on wide blocks?
www.troublefreepool.com
How to level above ground pool - Further Reading
www.troublefreepool.com
No, the pool is just on the soil. We spent forever leveling and clearing away debris. I guess I'll have to keep a close eye on it, to see if it settles any more. Are the submerged feet a problem if it stays at 2 inches unlevel?
- Jul 21, 2013
- 53,029
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
start over with putting it up - that low side is where all the spash-out is going to happen and that is going to keep those holes wet and the legs will sink more and worse, they will rust faster. use 3 or 4 inch thick pavers so they don't crack.