above ground bestway pool inground

Help guys!
Setting up my pool here in Uruguay. Did the hole and the walls with wood and water protection. All great. Leveled the sand and put styrene foam as a cushion. Installed the pool and then boom... rain! In a few hours it rained what was expected for a whole month. Water rose 45cm inside the wall and all the water in the plot of land went towards the hole I dig... now I need a solution. The pool was not filled up with water. I was supposed to fill it that next day.

Any ideas?
 

Attachments

  • IMG_20181212_190942.jpg
    IMG_20181212_190942.jpg
    76.7 KB · Views: 63
  • IMG-20181214-WA0018.jpg
    IMG-20181214-WA0018.jpg
    56.4 KB · Views: 61
  • IMG_20181217_221645.jpg
    IMG_20181217_221645.jpg
    49.5 KB · Views: 60
Pump out the water outside the pool and see what the ground looks like. If it looks okay the move on with filling the inside the pool. If it is a mess then pump out the inside of the pool and remove it from the hole and start all over :(
 
Did the back right corner sink into the ground? If so you need to pump out the pool and the hole and check the legs and make sure they didn't get bent. Did you have anything under the legs other than styrene? The legs need to be supported on concrete blocks or pressure treated wood.
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.