I cannot seem to get my omnilogic and heater to communicate, which I imagine is in the settings of the Heater. Does anyone have any experience with getting the two to communicate so i can adjust the temperature from Omnilogic? Thanks!
Jason thanks for the reply. I did get it fixed this morning after talking with Hayward I needed to delete the heater from omnilogic and reconfigure it. Works fine now!!! Thank you
Hold "set" button on heater for about 5 seconds until you see "Loc"
Then press the up arrow button until you reach 50 degrees
Set pool temp to off
Set spa temp to 104
Scroll "set" button til u get to the P_S section, then arrow til you get to "E"
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!