Closing on new house with pool in 2 weeks. I have already been reading some on here and noticed today that pressure seems a little high on pump. Was reading 22 and inspector back washed it for about a minute and it dropped to 20. The water was a little dirty for about 15 seconds of that flush before turning clear. The dial indicates a pressure between 20 and 30. Does this mean my pump setup will be normal at a 20 reading and I should flush it when it gets near the 30 mark?
Here are some pics of the setup. Its a 34x18 in-ground pool with a liner. Converted to saltwater last year and also a heater was added at that time. Pool water was very clear and nice looking today, didn't get a pic of that. Lots of equipment to learn to use. Pretty sure all the manuals are online but any advice is welcomed. I haven't ordered a test kit yet, need to pronto.
Not sure if the seller is running the system on the timer as the times weren't set correctly. Should I be running it all the time?
Here are some pics of the setup. Its a 34x18 in-ground pool with a liner. Converted to saltwater last year and also a heater was added at that time. Pool water was very clear and nice looking today, didn't get a pic of that. Lots of equipment to learn to use. Pretty sure all the manuals are online but any advice is welcomed. I haven't ordered a test kit yet, need to pronto.
Not sure if the seller is running the system on the timer as the times weren't set correctly. Should I be running it all the time?