So as you may have seen on one of my other threads, I swapped out my Jandy Plus HP 2.5 hp pump for a Pentair VS 3hp pump. After some challenges, the variable speed pump is working great, however the Salt Generator appears to not one to chlorinate below 1950 rpm's or so. Even more perplexing is that it will start chlorinating at 1100rpm and then switch to no flow, then I switch it up to a higher rpm and still it just sits in no flow. I had no issues with no flow before I switched the pump. I did take a look at the flow switch and it was perfectly clean. Do I just have to live with running the pump at a higher speed, is this normal for this Salt unit? My heat pump was working fine at 1950rpm, I would assume the salt generator would need less than that?
Just to add the Aquapure is part of the Aqualink PDA system.
Thanks
Just to add the Aquapure is part of the Aqualink PDA system.
Thanks