R
Latest activity Postings Media About
-
-
Rrobl45 replied to the thread Aqualink PDA and aquapure 1400 not showing percent in spa mode.No this is just pure spa, just draining from spa and putting in spa, pool cut off completely.
-
Rrobl45 replied to the thread Aqualink PDA and aquapure 1400 not showing percent in spa mode.Its actually a 1400 series. It was just the water flowing through the spa. Test was already at around 5, relatively bright yellow so...
-
Rrobl45 replied to the thread Aqualink PDA and aquapure 1400 not showing percent in spa mode.95 or 100%. Dont remember exactly but it was one of those.
-
Rrobl45 replied to the thread Aqualink PDA and aquapure 1400 not showing percent in spa mode.yes, I set it in service mode last night but and left it for a bit, it showed the percentage on there, but didn't appear to make any...
-
Rrobl45 replied to the thread pentair laminar.normally when its down, like it was yesterday when we went swimming, it is hitting the side more than that and just making a mess, I...
-
Rrobl45 replied to the thread Aqualink PDA and aquapure 1400 not showing percent in spa mode.That appears to be speaking about setting the percentage at the unit as opposed to setting it on the PDA which I am doing.
-
Rrobl45 replied to the thread pentair laminar.So as you can see, when its raised, it works perfect, when I put it back down, its working better today than yesterday, but you can see...
-
-
Rrobl45 replied to the thread Aqualink PDA and aquapure 1400 not showing percent in spa mode.Flow light is on, another light too but I don't remember which one and it says 00%
-
Rrobl45 replied to the thread Aqualink RS PDA.Yea, I had same problem and changed channel years ago and its been working okay, sometimes it goes to waiting but then eventually pops...
-
Rrobl45 replied to the thread Aqualink PDA and aquapure 1400 not showing percent in spa mode.Yea, its a PDA though not IAqualink, but yes, both parts are set, I even tried changing the spa part a couple of times.
-
Rrobl45 posted the thread Aqualink PDA and aquapure 1400 not showing percent in spa mode in Salt Water Chlorine Generators (SWG).Not sure if this is the right thread for this. My aqualink is controlling my aquapure just fine in pool mode, but in spa mode, it shows...
-
Rrobl45 replied to the thread My CYA experiment.I just dumped a whole bag in and might dump another bag in. My 40000 generator can't keep up with a 9000 gallon pool in Florida heat.
-
-
Loading…
-
Loading…
-
Loading…
