My pool is finally clean. Since I don't get a lot of sun to the pool, I need the heater periodically.
In any case, it seems that no gas is getting to the valve.
My question:
When I remove the pressure regulating ports (2x), should there be gas coming out if the valve is in the on position?
I have not checked electrical input but would this prevent gas from coming out of the pressure regulating ports?
I get no gas that comes out from either port. I have tried to get flow by adjusting the pressure positioning screw. yet no flow.
Valve markings: 394606 | VR8304M4853 | 24V 60Hz | 7A
In any case, it seems that no gas is getting to the valve.
My question:
When I remove the pressure regulating ports (2x), should there be gas coming out if the valve is in the on position?
I have not checked electrical input but would this prevent gas from coming out of the pressure regulating ports?
I get no gas that comes out from either port. I have tried to get flow by adjusting the pressure positioning screw. yet no flow.
Valve markings: 394606 | VR8304M4853 | 24V 60Hz | 7A