I "inherited" a 20 year old Morgan Spa with a recent move. It has a controller that is older than the Spa (dated 1982). It was running continuously on high speed til I shut off the main breaker a few weeks ago...big mistake. A few days ago the outside temp was going down to the single digits and water temp was 40F so I turned I back on....nothing. Figured the pump might be on a delay so I let it run. Came out to check it later and found water pouring out of the controller chassis! The heater which was part of the controller burst a seam somewhere.
So anyway...I'd like to leave the pump running on low speed. What's the typical plug pinout for a 2 speed motor? I'd like to direct wire the low speed connections and leave it that way til Spring when I will replace the spa pack/heater/pump. No one will use the spa during that time.
Thanks! Don
So anyway...I'd like to leave the pump running on low speed. What's the typical plug pinout for a 2 speed motor? I'd like to direct wire the low speed connections and leave it that way til Spring when I will replace the spa pack/heater/pump. No one will use the spa during that time.
Thanks! Don