Current Sensor/relay switching for SWG

[fcassini]

I am installing a Pentair VS superflow pump with built-in timer and Auto Pilot nano+ SWC. I would like to install a relay so the SWC is turned on when the pump runs but I can't understand how to do this. After reading posts about this I am confused on the wiring. Both my pump and SWC are 220V. Does anyone have any suggestions on relay needed and a wiring diagram? Thanks!

 

[jeffr47]

The new current switch was delivered today. I installed it and it works great. Finally my SWG powers on and off with my EcoTech VS motor. I don't have to rely in the flow switch.

Sent from my SM-T700 using Tapatalk

Not to resurrect an old post (as I do exactly that), but is this still working? Did you wire it as your diagram illustrates? I would like to do the same thing with my Hayward Maxflo and my SWG.