Hello Everyone! The guys are about done leveling the area outside, I am so excited. I have searched and read as many posts as I can here on the forum(and there are lots) but still want to ask a few questions.
Can anyone that has setup a rectangle pool tell me what you used under the legs and what size(height especially), along with the size of foam you used?
Has anyone had experience with using square pieces of wood under the legs vs one single long board as I have seen in a couple of posts? I plan to use wood, not pavers as most pavers break over time.
I am worried about using 1.5 inch board with 1 inch foam, is that going to cause it to not be level if the pool sinks down into the foam and the legs being up a bit higher??
Will the foam squish out a few inches as we fill with water? If so, then I should not let the foam meet the wood for the legs, correct? I should leave a few inches between the foam and my wood for legs, right?
I want to thank anyone in advance for your thoughts and info.
[/URL][/IMG]
Rkipper
Can anyone that has setup a rectangle pool tell me what you used under the legs and what size(height especially), along with the size of foam you used?
Has anyone had experience with using square pieces of wood under the legs vs one single long board as I have seen in a couple of posts? I plan to use wood, not pavers as most pavers break over time.
I am worried about using 1.5 inch board with 1 inch foam, is that going to cause it to not be level if the pool sinks down into the foam and the legs being up a bit higher??
Will the foam squish out a few inches as we fill with water? If so, then I should not let the foam meet the wood for the legs, correct? I should leave a few inches between the foam and my wood for legs, right?
I want to thank anyone in advance for your thoughts and info.
Rkipper