Hi All
I have installed a Raypak Digital Heater 206k BTU Natural Gas in a commercial facility. The heater display shows the set point at 104 degrees and the heater only heats the water to 99-100 degrees. There are no errors. I left it for a day and the the heater changed course and had a set point of 108 and water temperature of 103 without me touching it. I have changed the board (sent to me by Raypak) and the temperature sensor has been changed. Has anyone run in to this problem and what is the solution.
Many Thanks
James
I have installed a Raypak Digital Heater 206k BTU Natural Gas in a commercial facility. The heater display shows the set point at 104 degrees and the heater only heats the water to 99-100 degrees. There are no errors. I left it for a day and the the heater changed course and had a set point of 108 and water temperature of 103 without me touching it. I have changed the board (sent to me by Raypak) and the temperature sensor has been changed. Has anyone run in to this problem and what is the solution.
Many Thanks
James