When i run my pool without my polaris65 it will accumulate fine algae or pollen on the bottom even after manually vacuuming to waste the next day with pump running stuff is back on the bottom. When i turn the pool off and not run it over night then there is no accumulation on the bottom, none whatsoever. Then i turn the pool on and within 3 hours or so there is Crud on the bottom again. I have repeatedly vacuumed to waste. This seems like a filter issue. It is a 200 lb sand filter with a dual speed aqua tools 1.5 hp pump. Any insight on what the corn is going on here would be appreciated.
Again, this does not happen when the filter and pump are off. Only happens when it is running.
I have always done the bbb method even before reading it on here. I was an nspi tech back in the 90's.
3.5 fc
.1. Tc
7.6 ph
35 cya
160 ch
120 ta
Again, this does not happen when the filter and pump are off. Only happens when it is running.
I have always done the bbb method even before reading it on here. I was an nspi tech back in the 90's.
3.5 fc
.1. Tc
7.6 ph
35 cya
160 ch
120 ta